User Contributed                                           MET/CAL PROCEDURE
=============================================================================
INSTRUMENT:            HP 7015B Sub 2
DATE:                  19-Nov-97
AUTHOR:                User Contributed
REVISION:              0
ADJUSTMENT THRESHOLD:  70%
NUMBER OF TESTS:       3
NUMBER OF LINES:       55
CONFIGURATION:         HP 3325B
STANDARD:              Stanford Research FS700
=============================================================================
 STEP    FSC    RANGE NOMINAL        TOLERANCE     MOD1        MOD2  3  4 CON
  1.001  ASK+                                          X
  1.002  ASK-   R                    P                            F        W
  1.003  STD          Stanford Research FS700
  1.004  HEAD         {* TIMEBASE TEST *}
  1.005  JMP          2.001
  1.006  EVAL
  2.001  DISP         Set the UUT front panel controls as follows:
  2.001  DISP         CHART .......................................... RELEASE
  2.001  DISP         PEN ............................................... LIFT
  2.001  DISP         X INPUTS/X TIME BASE ....................... X TIME BASE
  2.001  DISP         RANGE (Y only) ............................... 0.1 V/in.
  2.001  DISP         TIME BASE .................................... 10 sec/IN
  2.001  DISP         RESET/SWEEP ................................ RESET (out)
  2.002  DISP         Install a new sheet of 10 x 10 per inch graph paper.
  2.003  DISP         Set the UUT front panel controls as follows:
  2.003  DISP         CHART ............................................. HOLD
  2.003  DISP         PEN .............................................. WRITE
  2.004  DISP         Connect the 3325A output to the UUT Y-axis input
  2.004  DISP         through a 50 ê feedthrough.
  2.005  IEEE         [@3325] FU 3; AM 500 MV; FR .1 HZ
  2.006  DISP         Using the X-axis ZERO control, position pen to exactly
  2.006  DISP         on the left most grid line.
  2.006  DISP         Use the Y-axis ZERO control to position pen for a
  2.006  DISP         centered up and down excurtion.
  2.007  DISP         When the Y-axis is near the top side of its travel,
  2.007  DISP         set the UUT front panel controls as follows:
  2.007  DISP         RESET/SWEEP ................................. SWEEP (in)
  2.008  HEAD         Long sweep time ...... Please wait.
  2.009  IEEE         [D30000][D30000][D30000][D10000]
  2.010  HEAD         TIMEBASE TEST
  2.011  DISP         Set the UUT front panel controls as follows:
  2.011  DISP         PEN ............................................... LIFT
  2.011  DISP         RESET/SWEEP ................................ RESET (out)
  2.012  IEEE         [@3325] AM .0005 VR
  2.013  DISP         Mark the first peak from left most grid line and count
  2.013  DISP         the number of minor divisions to the last peak from
  2.013  DISP         the right most grid line (nominal is 90.0 divisions).
  2.014  MEMI         Use keyboard to enter actual number of minor divisions.
  2.015  MATH         MEM1 = 90.0
  2.016  MEME
  2.017  MEMC         divisions      1.5U
  3.001  END